1Reply24 days ago | 24 days agoAll controls stop working Halfway through a cycle, all actions stop operating. None of the valves turned on when they were supposed to...doors wouldn't open. I went into service mode to inputs/outputs and tested the door and all the water valves and nothing would operate/energize. I checked the incoming air at the regulator and it was fine. What else should I be checking? What could cause this? Thank you. Reply |
-Michele.l.thomas01 24 days ago | 24 days agoSTERIS - Reliance Vision Single Chamber Washer is stuck on Steris Logo screen At startup, the system goes to the desktop screen then the Steris screen with the progress bar. After the progress bar, it still just sits on the Steris screen. Can someone tell me how to access the Softlogix Controller to verify it's on 'run' mode? Thank you.Reply |
0Replies7 months ago | 7 months agoCPU issue CPU and hard drive went out. Replaced Allen Bradley CPU and cloned hard drive from another SC Vision Washer. Turned unit on and it went thru its normal booting process, then it stopped and asked for the Administrator Password. called Steris and they said it was an AB issue, called AB and they said it was a Steris issue. Sounds almost like Steris doesn't want to help because I didn't purchase the CPU from them. Reply |